Skip to main content
Home/Repair/Water Damage Repair
Emergency lab Treatment • 85%+ Data Recovery Rate

Emergency PhoneWater Damage Repair

Dropped your phone in water, pool, or coffee? Act quickly before galvanic oxidation destroys delicate logic board copper traces. Our lab combines ultrasonic chemical baths, thermal imaging, and micro-soldering to resurrect drowned devices.

Ultrasonic Chemical Bath
90-Day Priority Warranty
Board Micro-Soldering

Our 4-Stage Liquid Recovery Protocol

How we stop corrosion and safely salvage drowned circuitry.

1. Immediate Power Down & Disassembly

Technicians disconnect the battery immediately to cut off active voltage that causes electrolytic motherboard corrosion.

2. Ultrasonic Chemical Bath

The circuit board is submerged in an industrial ultrasonic transducer using pure 99.9% isopropyl alcohol and chemical flux to dissolve mineral salts.

3. Thermal Camera Short Detection

Infrared thermal imaging highlights shorted capacitors and overheated power ICs under microscopic voltage injection.

4. Component Micro-Soldering

Corroded SMD resistors, diodes, and BGA power management ICs are replaced with fresh leaded solder joints.

Water Damage FAQs

Does putting a wet phone in rice actually work?▼

NO! The 'rice trick' is an urban myth that damages phones further. Rice does not draw moisture out of sealed internal enclosures. Instead, raw starch powder enters speaker grilles and charging ports, creating sticky cement that accelerates copper trace corrosion. Power off your phone immediately and bring it to a professional repair lab.

Can data be recovered from a water-damaged phone that won't turn on?▼

Yes! In over 85% of liquid damage cases, flash memory NAND chips survive intact. Even if the screen or entire phone is beyond economical repair, we can revive the CPU/NAND rail to extract your photos, contacts, and personal data.

What should I do right after dropping my phone in water?▼

1) Turn the device OFF immediately. 2) Do NOT plug it into a charger. 3) Do NOT shake the phone or blow hot air with a hairdryer (which forces water deeper into display layers). 4) Book an express emergency lab slot with Revora.

Phone pani me gir gaya: Kya karna chahiye aur kya phone thik ho sakta hai?▼

Agar phone pani me gir gaya ho: 1) Phone ko turant switch off karein. 2) Charger me bilkul mat lagayein. 3) Chawal (rice) me mat daalein kyunki rice se corrosion badhti hai. 4) Revora me ultrasonic chemical bath ke liye book karein. 85%+ pani me gire phones bilkul thik ho jaate hain.

Device beyond economical repair?

We buy water-damaged and dead phones for scrap IC value with instant UPI cash payout.

Sell Dead Phone for Cash